Table of Contents
Advertisement
1
System Startup
A: When power is supplied to the control, the screen will display the time of day, gallons remaining and the regeneration
mode. Press and hold the CYCLE button for 5 seconds until you see the words "goto bW" and then release the CYCLE
button. The backwash (bW) will be underway.
B: Once the valve is in the backwash (bW) cycle, you will see the 15-minute (015) countdown next to "bW". Open the inlet
on the bypass valve slowly and allow water to enter the unit. If you hear any large "knocking" sounds, turn the red inlet
valve partially closed (not all the way) as the water is being fed too quickly and should be slowed. This process will
begin to purge air from the resin tank and fill the resin tank with water, allowing the air to escape to the drain line.
The water to the drain line will eventually start to run clear after 3-4 minutes.
C: After the backwash you will see the system move into the brine draw (bd). The brine draw is 60 minutes total and will
normally draw out the saltwater within 20-30 minutes leaving the rest of the time for the saltwater to bond with the
resin. After the brine draw (bd), the rapid rinse (rr) will start for a duration of 10 minutes. Allow the entire cycle to run so
the resin is rinsed clean.
D: When the rinse cycle is complete, the control screen will move on to the brine fill (bF). This phase will fill water back
into the brine tank. You should gradually start to see the water level rise to half a tank full. Let the entire brine fill finish.
E: When the regeneration cycle is complete, open the outlet side of the bypass completely allowing water to flow into
your home. From this point, locate the nearest treated water faucet. Remove the aerator screen and run the cold water
until the water is completely clear. Once done, shut off the faucet water and place the aerator screen back on the faucet.
2
Programming The System
IMPORTANT!
!
The settings are pre-programmed from the factory to work with the majority of homes.
We recommend programming the system from settings 1 - 4 and leave settings 5 - 8 at
system default unless the condition of water requires adjustment.
Enter Setting Menu by pushing both the Setting button and Up button at the same time. The screen
will jump from the service screen with the faucet icon to the first setting screen to set time.
11:30
1000
gAL
www.proaquawater.com
Valve Programing
11:30
SEt - 1 tIME
FLASHING
17
Advertisement
Table of Contents
