Table of Contents
Advertisement
System Installation
5
Connecting the Brine Tank
A: The brine tank system is 90% pre-assembled. To finish the setup, begin by removing the black lid of the tank
and the white lid on the brine well. Push the brine line through the top hole on the side of the brine tank, and also
through the opening in the brine well. Connect the brine line to the quick connection in the float valve and give it
a tug to make sure it is fully connected.
B: Place the white lid back on the brine well and pour
80 lbs (two bags) of water softener salt pellets and 5
gallons of tap water into the brine tank. Place the
black lid back on the brine tank.
NOTE:
*
The optional brine tank overfill connection is not required since the brine well is equipped with an
automatic shutoff valve. If you want to utilize this feature, purchase and install a ½" plumbing hose
to this connection and run it to the drain.
14
BRINE
WELL LID
BRINE TANK
OVERFILL
BRINE
LINE
FLOAT
VALVE
Have questions? Call 1-800-980-3335
BRINE
WELL
Advertisement
Table of Contents
