Table of Contents
Advertisement
3
Connecting the Drain Hose
A: Remove the orange locking clip on the drain line elbow. Locate
the included 1/2" drain hose. Use a sharpie to mark 1/2" from one
end of the hose and push that end into the quick connect drain
port on the valve until it reaches or passes the 1/2" mark.
Replace the orange locking clip and pull the line to check that
it is secured.
B: Run the drain hose either overhead or along the floor to
the nearest laundry tub or drain. The drain hose should be a
minimum of 1/2" in width but if you are running the drain line
more than 20 ft linear, it is recommended to increase the hose
size to 3/4" and be sure there are no sags in the hose all the
way to the drain destination.
NOTE:
*
A direct connection into a waste drain is not recommended.
A physical air gap of at least 1.5" Should be used to avoid
bacteria and wastewater traveling back through the drain
line into the system.
4
Connecting the Brine Hose
Remove the blue locking clip on the brine line port on the
valve. Mark the included 3/8" brine hose 1/2" from one end
of the hose with a sharpie. Connect that end to the control
head by pushing it into the quick connect brine port until
it reaches or passes the 1/2" mark. Replace the blue locking
clip and pull the line to check that it is secured.
DRAIN
HOSE
BRINE
HOSE
www.proaquawater.com
System Installation
LOCKING CLIP
1/2"
LOCKING
CLIP
1/2"
13
Advertisement
Table of Contents
