System Installation - PRO+AQUA PRO-S-80E Installation Manual

Whole house water softener
Table of Contents

Advertisement

System Installation

IMPORTANT!
!
DO NOT SOLDER WHILE SYSTEM IS CONNECTED. Any solder joints being soldered near the valve must be done
before connecting any piping to the valve. Failure to do this could cause unrepairable damage to the valve.
1
Shut Off Main Water Supply
Locate the main water supply valve for the house
and turn it off.
2
Connecting The System
The control valve is equipped with 1" male NPT
connections. It is recommended that these
connections are made using 8-12 wraps of
plumber's tape. The inlet and outlet can be
identified by the arrows stamped in the
bypass valve showing the flow direction. The
arrow pointing toward the valve is the inlet
and the arrow pointing away from the valve
is the outlet.
A: Apply Teflon tape onto the inlet and outlet
fittings.
B: Connect the inlet and outlet of the system
using appropriate fittings.
C: All piping should be secured to prevent
stress on the bypass valve and connectors.
12
Have questions? Call 1-800-980-3335
MAIN WATER LINE
OFF
TEFLON TAPE
AREA
18" FLEX
HOSES
FROM SOURCE
TO HOME

Advertisement

Table of Contents
loading

Table of Contents