1- Safety Regulations; Conformity Of Use; Safety Symbols - Electron E-ROBOT+3 Series User Manual

1. Safety Regulations
This section sets out the fundamental safety regulations that must be followed by the user and third
parties using the E-ROBOT+3 Z
These safety regulations must be read and understood before the E-ROBOT+3 Z is used.

1.1. Safety Symbols

The following warnings with their meanings can be found in the Sistem Teknik Makina operating instructi-
ons. The general safety precautions must also be followed as well as the regulations in the operating instructions.
DANGER!
Live electricity or moving parts are dangerous.
Possible Consequences: Death or serious injury.
WARNING!
Improper use of the equipment could damage the machine or cause it to malfunction.
Possible consequences: Minor injuries or damage to equipment

1.2. Conformity Of Use

E-ROBOT+3 Z-Axis Reciprocator is built to the latest specification and conforms to the recognized tech-nical
safety regulations. It is designed for the regular application of powder coating.
•
Any other use is considered as non-conform. The manufacturer is not responsible for damage resulting from
impro-per use of this equipment; the end-user alone is responsible. If the E-ROBOT+3 Z is to be used for other
purposes or other substances outside of our guidelines then Sistem Teknik Makina A.Ş. should be consulted.
•
Observance of the operating, service and maintenance instructions specified by the manufacturer is also part of
conformity of use. The E-ROBOT+3 Z should only be used, maintained and started up by trained personnel, who
are informed about and are familiar with the possible hazards involved.
•
Start-up is forbidden until it has been established that the E-ROBOT+3 Z has been set up and wired according to
the guidelines for machinery EN 60204-1 (machine safety) must also be observed.
•
Unauthorized modifications to E-ROBOT+3 Z exempt the manufacturer from any liability of resulting damage.
•
Relevant accident prevention regulations, as well as other generally recognized safety regulations, occupational
health and structural regulations are to be observed.
•
In addition to above, country-specific safety regulations must be observed.
Explosion Protection
II 3 D
Explosion Protection Class ofE-ROBOT+3 Z
Protection Type
Note: EN 60204-1 standard includes the non-mobile machines electronic machines and
programmable electronic hardware and systems.
IP54
Temp Class
T135 °C
5