M.2 Backplane Cable Routing - Lenovo ThinkEdge SE455 V3 User Manual

d. Connect the cable to
e. Route the cable away from the PSU cage as shown.
Figure 210. System-board power 1 cable routing
Step 6. Connect System-board power 1 cable.
5
a. Connect the cable to
b. Route the cable into cable clip
c. Twist the cable as shown, and connect it to
on the system board.
d. Close cable clip

M.2 backplane cable routing

Follow the instructions in this section to learn how to do cable routing for the M.2 backplane.
Proceed to the section corresponding to the selected configuration.
Configuration
"M.2 backplane to system board" on page 235
"M.2 backplane to RAID adapter" on page 236
234 ThinkEdge SE455 V3 User Guide
PDB sideband connector on the PDB.
4b
System board power connector 1 on the PDB.
5a
.
C
to secure the cables.
C
System board power 1 connector (PDB PWR 1)
5b
Cable
• One M.2 power cable, 350mm
• One M.2 signal cable, Slimline-LP x4 to Slimline x8,
400mm
• One M.2 power cable, 350mm
• One of the following M.2 signal cable:
– To x350 RAID adapter: One M.2 signal cable,
MiniSAS-HD x4 to Slimline x8, 500mm
– To x40 RAID adapter: One M.2 signal cable, Slimline
x8 to Slimline x8, 500mm