Lenovo ThinkEdge SE455 V3 User Manual page 257

3. Install the processor air baffle. See
4. Install the PCIe riser assemblies. See
5. Proceed to "Complete the BP cable routing" on page
RAID to front SATA + system board to internal NVMe BP
1. Connect the internal BP signal cable to the connectors on the system board in the following order:
a. PCIe 11
b. PCIe 10
2. Route the internal BP signal cable through the cable wall; then, secure the cable into cable clip
Note: Route one cable branch through the cable wall first; then, route the other through the cable wall.
3. Secure the front BP signal cable in cable clip
Figure 226. Cable clip C
"Install the processor air baffle" on page
"Install the PCIe riser assembly" on page
251.
.
C
73.
155.
.
Chapter 6 Internal cable routing
.
A
249