Table of Contents
Advertisement
Figure 170. Connecting the extension cable
Step 2.
Install the RAID flash power module.
a.
Insert the RAID flash power module into the holder with the orientation shown in the
illustration. Make sure that the end of the module is placed as shown.
b.
Pull back the retention clips; meanwhile, press the cable side of the flash power module
down until it is seated in place.
Figure 171. Installing the RAID flash power module
After this task is completed
Complete the parts replacement. See
RAID flash power module holder replacement
Follow instructions in this section to remove and install the RAID flash power module holder.
Remove the RAID flash power module holder
Follow the instructions in this section to remove the RAID flash power module holder.
About this task
S002
"Complete the parts replacement" on page
225.
.
Chapter 5
Hardware replacement procedures
191
Advertisement
Table of Contents
Troubleshooting
