Table of Contents
Advertisement
FASTENING THE COOKTOP
Each cooktop is provided with an installation kit
including brackets and screws for fastening the
cooktop to benches from 30 to 40mm thick.
30, 60 and 75cm wide models (fig. 1.2a, 1.2b):
The kit includes two "F" type brackets (for the
front of the cooktop), two "R" type brackets (for
the rear of the cooktop) and four self-threading
screws "S".
90cm wide models (fig. 1.2c): The kit includes
four "F" type brackets (for the front of the cooktop),
three "R" type brackets (for the rear of the cooktop)
and seven self-threading screws "S".
•
Cut the unit according to the dimensions in
fig. 1.1a or 1.1b.
•
Models in fig. 1.1, 1.2, 1.3, 1.5, 1.9, 1.10, 1.11
of page 25, 26: stretch gasket "G" over the
edge of the hole made, being careful to
overlay the junction edges (fig. 1.2d, 1.2e).
•
Models in fig. 1.4, 1.6, 1.7, 1.8 of page 25, 26:
spread the longer seal "G1" around the left,
rear and right sides (fig. 1.2f).
•
Fasten the brackets "F" and "R" to the
appropriate socket holes, without tightening
the screws "S" for the moment. Make sure
that the tabs are mounted correctly, as
shown (figs. 1.2h, 1.2i). Rotate the tabs so
that the cooktop can be put into the cutout.
For the models in figs. 1.4, 1.6, 1.7, 1.8 of page
25, 26, stretch the tightest gasket "G2" along
the entire perimeter of the cooktop. (fig. 1.2g).
•
Put the cooktop into the cutout and position
it correctly.
•
Put the brackets "F" and "R" into place; tooth
"A" of the brackets should go into the hole
(figs. 1.2h, 1.2i).
•
Tighten screws "S" until the cooktop is
completely secured to the bench.
•
Using a sharp cutter or trimmer knife, trim
the excess sealing material around the edge
of the cooktop.
Take care not to damage the workbench.
In case to install the hob flush with the work
•
surface, fill any gaps between the glass and
along the perimeter of the work surface with
insulating silicone, and wipe away any excess.
12
12
R
R
F
R
R
R
F
R
Fig. 1.2a
F
R
Fig. 1.2b
F
Fig. 1.2c
R
R
F
F
F
G
Fig. 1.2d
Fig. 1.2e
G
G1
F
R
F
F
Advertisement
Table of Contents
