Double-Ring Compact (Drc); Double-Ring (Dr) - Elba ELIO 95-565 CG Instructions For The Use - Installation Advices

CHOICE OF THE BURNER (Type B)
On the control panel, near every knob there is a diagram that indicates which burner is
controlled by that knob.
The suitable burner must be chosen according to the diameter and the capacity used.
The burners and pans must be used in accordance with the following instructions:
DIAMETERS OF PANS WHICH MAY BE USED ON THE BURNERS
Double-ring compact
Dual (inner crown only)
Dual (outer crown only)
Dual (inner+outer crown)
(*)
with small pan adapter (optional): minimum diameter 6 cm

(**) minimum diameter 12 cm only for the model in fig. 1.1 at pag. 25
It is important that the diameter of the pot be suitable to the potentiality of the burner so as
not to compromise the high output of the burners and therefore energy waste.
A small pot on a large burner does not give you a boiling point in a shorter amount of time
since the capacity of heat absorption of a liquid mass depends on the volume and the
surface of the pot.
CAUTION: Make sure the pans are central to the burner for maximum stability and greater
efficiency.
Make sure the pans are not in contact with the control knobs, otherwise the flame could
overheat the knobs and permanently damage them.
BURNERS
Auxiliary
Semi-rapid
Rapid
Double-ring
do not use pans with concave or convex bases
MINIMUM
12 cm (*)
16 cm (**)
24 cm
26 cm
26 cm
12 cm (*)
26 cm
26 cm
Fig. 2.3b
MAXIMUM
14 cm
24 cm
26 cm
28 cm
28 cm
14 cm
28 cm
28 cm
31 31