Replacing Heat Demand And Transformer - Pitco SELV Series Manual

19.1 Replacing Heat Demand and Transformer

!
DANGER
Prior to moving, testing, maintaining or repairing
your appliance, ensure it is emptied of all oil,
cool, disconnected from electric and all electrical
power. Failure to do so may result in property
damage, damage to your fryer, injury or death.
Remove the two (2) screws using a Philips
1.
screwdriver front the front cap strip and two (2)
screws from the panel.
!
L22-393 R0 Page 64
2. Lower the front cover to a flat position.
Depending on model or date of equipment,
relay board may look different than picture
below.
3. Depending on what you need to do you can
remove four (4) screws using a phillips screw
driver and lay down the relay board on the front
cover with molex connectors in place or unplug
all molex connector (you might want to take a
snap shot of connectors before removing for
reference for installing back) and remove the
four (4) screws to completely.
PLEASE NOTE: MOST OF THE MOLEX
PLUGS ARE LABELED WITH CONNECTION
POINT ON RELAY BOARD.