Heat Demand Relays; Circuit Breaker; Hood & Filter Relays - Pitco ME14S-C/MFD Service Manual

Electric fryer with filter, manufactured exclusively for mcdonald's

Table of Contents

Pivot the front panel down and allow the computer

to be supported on the mounting tabs.

Unplug the computer/controller wiring harness. The

front panel can now be removed by pulling the com-

plete assemby forward.

Remove the lower cover by removing the 2 screws

located in the bottom of the cover.

All of the components mounted in the front panel

can now be accessed through the opening.

Heat Demand Relays:

Mounted on the rear brace of each fryer unit you will

find the Heat Demand Relay housing. Remove the

cover of the housing from the front of the machine.

The Relays can now be seen from the front, they are

mounted to the Heat Sink using 2 screws. Terminals

1 & 2 are the load connections and terminals 3 & 4

are the 24VAC input terminals.

Remove the mounting screws on either side of the

cover. Turn the cover over and the circuit breaker

can be removed from the cover.

Hood & Filter Relays:

These relays are always wired in the following man-

ner -

Table of Contents