Table of Contents
Advertisement
PREVENTATIVE MAINTENANCE
5.1.2 FLUSH HOSE OPERATION (if equipped)
The cooker tank can be rinsed cleaned by using a filter flush hose (if equipped). Refer to the previous section in
this document to turn the fryer off and drain the oil into the filter pan. During step # 2 for manual models or step #5
for automatic models use the following procedure to operate the filter flush hose.
Resetting either the filter pump circuit breaker or the filter pump motor thermal overload may cause unex-
pected hot oil discharge if a refill switch or flush hose valve (if equipped) is left in the ON position. Always
verify the appliance is turned OFF and that the filter return switches, or the flush hose valves (if equipped) are
OFF and safely positioned before resetting the breaker or thermal overload.
ALWAYS use Personal Protective Equipment when working with the Flush Hose Option. Contact with hot oil
1.
Connect the filter flush hose to the quick connecting fitting.
Point the filter hose nozzle outlet into the empty frypot.
2.
3.
Pull the yellow handle to turn the pump on and allow oil/shortening to flow through the flush hose.
4.
Use the flush hose to rinse cooking debris from sides and bottom of the fry pot, flushing it through the
drain and into the filter pan.
5.
When the tank has completed filling, push the yellow handle to deactivate the pump.
5.1.3 REPLACING THE FILTER MEDIA (if equipped)
Refer to the following procedure to replace the filter media if the appliance is equipped with a filter drawer. The
diagram below shows a Solo Filter style pan and associated parts. Additional filter types are available.
1.
Detach the pickup tube from the filter pickup assembly by
unscrewing it (counterclockwise), at the knurled fitting,
from the threaded fitting on the filter screen.
2.
Slide off the filter paper clip and remove used filter paper
from filter screen. Clean and completely dry pan and pan
components. Replace with new filter paper, ensuring that
the hole in the paper is on the top, so that threaded fitting
in filter screen protrudes through it.
3.
Fold filter paper to the underside of the filter screen and
replace filter paper clip.
4.
Re-attach filter pickup tube to the filter screen by screwing
it (clockwise) into the threaded fitting in filter screen.
5.
Reinstall the filter pickup assembly into the filter system
by placing the newly covered screen portion of the
assembly into the filter pan and connecting the quick
disconnect on the filter pickup assembly into white donut
fitting on the left-hand side of the appliance. Ensure that it
snaps tightly and securely into donut fitting.
The power supply must be disconnected before cleaning and servicing this appliance!
The contents of the crumb catch and/or filter pan of any filter system must be emptied into a fireproof container
at the end of the frying operation each day. Some food particles can spontaneously combust into flames if left
L20-406 Rev 7 (01/17) Page 20
WARNING
WARNING
can cause serious injury.
WARNING
WARNING
soaking in certain oil/shortening materials.
1. Filter Pan (Solo Filter shown)
2. Filter Pickup Assembly
3. Filter Strainer Cap
4. Filter Paper
5. Filter Screen
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
