Changing Filter Pump Actuator - Pitco SELV Series Manual

11 Changing Filter Pump Actuator
1. Pull two (2) re-usable cotter pins. One is
located in the front of the actuator unit,
second is located in the rear of the
actuator.
2. From the front, unplug the four pin molex
connector for the actuator.
3. Remove filter pump actuator.
4. Follow steps 1 through 3 in reverse to
reinstall new filter pump actuator.
Re-assembly is simplified if the cotter pin in the
rear is installed BEFORE the cotter pin in the
front of the fryer.
L22-393 R0 Page 35
NOTE