Wireless Communication Function (Sj-Wp-Bt Model Only); Wireless Communication Initial Setting - AND SJ-WP Series Instruction Manual

10. Wireless Communication Function
(SJ-WP-BT model only)
The SJ-WP-BT model has a wireless communication function.
Connectable devices are shown below.
Connectable devices
AD-8541-PC (wireless communication interface for PC) *1
AD-8931 (wireless remote display) *1
Tablets/smartphones *2
*1: Separately available
*2: The purpose-built application, the A&D WeiV (iOS/Android), is required.
This product is not paired with the wireless receiver at the time of shipment. In order to use,
it is necessary to perform the procedure in
below. The SJ-WP-BT model can be paired with one wireless communication device.
Note: The wireless communication function is a built-in option already
incorporated at the time of factory shipment. Therefore, please note that it
cannot be added to a SJ-WP model later.

10.1. Wireless Communication Initial Setting

1. While the power is off,
(For the AD-8541-PC) press and hold the "connection switch" of the AD-8541-PC
(For the AD-8931)
2. Turn on the power and wait for a while. If there are multiple scales or balances, turn
off the power of those other than the one to be connected.
3. When pairing is successful, the "Wireless communication mark" lights up on the
display. From next time, connection will be established automatically.
4. If the connection is not successful, please refer to the instruction manual of the
wireless communication receiver.
"10.1. Wireless Communication Initial
until the LED lights in orange (about 3 to 4 seconds).
turn on the AD-8931, and press and hold the SET key
until the connection mark starts blinking.
19
Setting"