Screed Program - SOLARFOCUS ecotopzero Manual

6 Heating circuit

6.1.5 Screed program

ATTENTION - This is a screed drying pro-
!
gram, which needs to be adjusted precisely to
the specifications of the screed installer.
After clicking on the screed button, a pop-up window
will appear immediately, which reminds you once
again to adapt the setting values according to the spe-
cifications of a specialist company.
After selecting Continue, you can press the Program
start button whereupon you will be asked again if you
really want to start the program.
Once the drying program has been started, it will con-
tinue automatically depending on which protocol is
set, and it will switch off automatically at the end.
Also check the heating circuit settings (heating curve,
maximum flow temperature), as the heating circuit
automatically switches over to the control function set
at the end of the drying program. To ensure that the
required flow temperature can be maintained, ensure
that sufficient fuel is being supplied to the boiler.
26
1 Maximum temperature
2 Start temperature
3 Temperature increase
4 Temperature reduction
5 End temperature
6 Heating time
7 Delay time
8 Lowering time
9 Screed protocol
10 Start/stop program
ATTENTION - Once the function has started,
!
the values can no longer be changed. If
changes are made to the protocol, the drying
program must be manually switched off. Fol-
lowing reactivation, it will start on the first day
again.
Pressing the button opens the Screed
protocol screen in which the
individual set values of the individual
stages for the required flow tem-
peratures are displayed along with their
progress.
denotes the relevant active stage.
marks the completed stages.
Operation manual ecotop-zero, ecotop-light