Table of Contents
Advertisement
6:
Terminate the two thimbles from the motor end sling to a shackle and the two thimbles from the
tail end sling to another shackle.
7:
Terminate both of these shackles to a single lifting shackle.
8:
With an appropriately sized lifting device, slowly lift the hoist from its crate until it is roughly
1.2 m (4'-0") above the floor. Clear the area of the crate and packaging.
9:
Thread the supplied lifting ring in to the hole on the tail end of the hoist backbone as shown and
terminate the end of a second lifting device to the lifting ring.
10:
Incrementally raise the tail end lifting device while lowering the centered lifting device to change
the orientation of the hoist from horizontal to vertical. This should be done in a slow and
controlled manner.
Installation
1.2 m (4'-0")
21
Advertisement
Table of Contents
