Table of Contents
Advertisement
adding support. The threaded rod bends and applies constant pressure to the backbone
stiffeners to minimalize vibration and noise. Repeat for the Tail End set of beam clamps.
9:
Using a 1/4" allen key, tighten all four 5/16 x 18 socket head screws on the two Tail End sliding
beam clamps to 13.5 Nm (10 ft/lb).
10:
Tighten the set screws on the backbone stiffener clamps. Torque the screws to 13.5 Nm (10 ft/
lb).
Installation
13.5 Nm
10 ft/lb
17
Advertisement
Table of Contents
