Installation; General Information On Installation - ETC Vortek NXT Installation And Operation Manual

Installation

General Information on Installation

Vortek NXT Hoist Installation Tool List
A non-metric tool set is required for the Vortek NXT hoist installation.
• 9/16" Combination Wrench
• 3/4" Combination Wrench
• 3/8" Drive 7/16" Socket
• 3/8" Drive 1/2" Socket
• 3/8" Drive 9/16" Deep Well Socket
• 1/2" Drive 3/4" Deep Well Socket
• 3/8" Drive Torque Wrench
• 3/8" Drive Ratchet
• 1/2" Drive Ratchet
• 18" Long 3/8" Drive "Wobble" Extension or Universal
• 1/4" Allen Wrench
• 3/32" Allen Wrench
• 10 mm socket
• Cordless Drill with 3/8" Drive Attachment
• Tape Measure
• Metal Banding Cutter
• Nicopress swage tool for 3/16" wire rope
• Cable Cutter
• Electrical Tape
• Utility Knife
• Laser Level
• Rubber Mallet
WARNING:
10
Use of incorrectly sized tools may cause damage to the machine.
Vortek NXT Hoist Installation Manual