Table of Contents
Advertisement
In these operating instructions, buttons to be pressed are shown in fat, menu
entries or display messages are shown in [square brackets] and operating
messages with an arrow >.
Note on operating the device:
The ▼ TUNING/OK ▲ rotary knob can be turned and pressed. Pressing the
▼ TUNING/OK ▲ rotary knob: Select / Confirm
Turn the ▼ TUNING/OK ▲ rotary knob: station selection / option selection in the
Menu.
7.1 Switch on the device
>
You can switch on the DIGITRADIO 574 IR by pressing the
button (1) on the device or the
control.
After switching on for the first time, you must first select the operating
language with ▲ /▼ and confirm the selection with OK. You can then start
the setup wizard. Here you can, for example, update the date and time either
via DAB+/UKW or the Internet. An attempt is then made to establish a
connection to a WLAN network. To do this, select the appropriate Wi-Fi
network and enter the Wi-Fi password using the remote control if necessary.
Detailed
Information on the settings in the setup wizard can be found in chapter "17.9
Setup wizard" on page 33.
7.2 Switch off the device
>
You can switch the DIGITRADIO 574 IR to standby by pressing the
On/Standby button (1) on the device or the
the remote control. The date and time appear on the display.
7.3 Operating the device with the remote control
You can use the infrared remote control to operate the most important functions of the
appliance from the comfort of your seat. Please note the following points when
operating the appliance with the remote control:
Point the remote control at the IR receiver (9) on the front of the appliance.
>
>
There must be a line of sight between the remote control and the IR receiver.
>
If the range of the remote control decreases, the BaGeries should be
replaced with new ones.
The maximum range is approximately 5 metres in front of the device.
16
On/Standby button (14) on the remote
On/Standby button (14) on
On/Standby
Advertisement
Table of Contents
