Using Headphones; General Device Functions; Switching On The Device; Switching Off The Device - TechniSat DIGITRADIO 370 CD IR Manual

4.3.4 Using headphones

Hearing impairment!
Do not listen to the radio at a high volume with headphones. Doing so can cause
permanent hearing impairment. Turn down the radio volume to the lowest volume
before using headphones.
Only use headphones with a 3.5 mm stereo jack plug.
> Insert the headphone plug into the headphone jack (16) on the device.
Sound will now only be heard via the headphones, the speaker is switched to
mute.
> If you would like to use the speakers again, unplug the headphones from the
headphone jack on the radio.

4.4 General device functions

4.4.1 Switching on the device

> In order to guarantee good DAB+/FM reception, please fully extend the
telescopic antenna (14) located on the back of the device. To do so, please
refer to Section 4.3.1.
> First prepare the DIGITRADIO 370/371 CD IR for operation as described in
Sections 4.3.1 and 4.3.3.
> Press the
to switch on the DIGITRADIO 370/371 CD IR.
After switching on the device for the first time, you must first configure the
operating language and the initial installation wizard.

4.4.2 Switching off the device

> By briefly pressing the
standby mode. [Standby] appears briefly on the display. The date and time
are shown on the display. The display brightness in standby mode can be
adjusted by following the instructions in Section 16.12.
58
On/Standby button on the device (2) or the remote control (14)
On/Standby button you can switch the device to