Table of Contents
Advertisement
14 Audio input
You can play the sound of an external device via the speakers of the DIGITRADIO
574 IR.
Connect the external device to the AUX-IN connection (19, 3.5 mm
>
stereo jack) on the back of the DIGITRADIO 574 IR.
Use the MODE button to select the AUX-IN audio input. The display shows
>
[Aux-In] is displayed.
Control and playback are performed on the external device. Do not set the
volume too low to avoid background noise.
15 Advanced functions
15.1 Sleep function
Press the MENU button and then select [Main menu > Sleep].
>
Alternatively: Press the SLEEP button(2).
>
You can use the ▲ or ▼ buttons to set the time period after which the
appliance switches to standby in each operating mode in steps of 15, 30, 45,
60, 90 and 120 minutes.
A moon symbol appears in the status bar of the display with the time
remaining until the DIGITRADIO 574 IR switches to standby.
15.2 Alarm clock
Press the MENU button and then select [Main menu > Alarm clock].
>
Alternative:
Press the Alarm clock button (17) to jump directly to the alarm clock
>
configuration.
15.2.1 Setting the alarm time
You can only operate the alarm function once the correct time has been
set. Depending on the configuration, this is done automatically or must be
set manually. The time can be updated either manually, via DAB+/UKW or
via the Internet. Further information on this can be found in chapter 17.4.
Select one of the alarm time memories Alarm clock 1 or Alarm clock 2
>
using the ▲ or ▼ buttons and confirm with OK.
>
Then go through all the points in sequence. Confirm each entry with the
OK button.
27
Advertisement
Table of Contents
