Epilog Laser Fusion Maker Manual page 9

17000 - CO2 Laser Alignment
4. Remove the upper mirror cover at the
back left corner of the engraver:
5. Adjust the red dot position so it is
centered on the alignment target
using the three (3) Allen adjustment
screws located on the back of mirror 2:
Mirror 2 Adjustment Screw Guide
6. Once the red dot position is centered
on the alignment target, move the
carriage back to position 1.
7. If the red dot position is still centered
on the alignment target while the
lens carriage is in position 1, move to
Adjusting Mirror/Position 3.
8. If the red dot position is no longer
centered on the alignment target
while the lens carriage is in position 1
after adjusting position 2, adjustments
to mirror/position 1 will need to be
made again.
9. Move between positions 1 and 2,
adjusting the respective mirror for
each position until the red dot is
centered on the alignment target at
both positions.
In some cases, this process can take
several back and forth movements be-
tween positions 1 and 2. Ensure that the
correct mirror is being adjusted for each
position.
Adjusting Mirror 3/Positions 3&4
1. Ensure that the red dot pointer is
activated.
2. In Alignment Mode, press Top Right to
move the lens carriage to the top right
corner (position 3) of the engraver.
3. Inspect the location of the red dot in
relation to the center of the alignment
target. If the red dot pointer is not in
the center of the alignment target,
adjustments will need to be made to
mirror 3.
9