1. Manuals
  2. Brands
  3. Epilog Laser Manuals
  4. Engraver
  5. FiberMark
  6. Manual

Epilog Laser FiberMark Manual

Fiber laser replacement
Hide thumbs Also See for FiberMark:
1
2
3
4
Table of Contents

Advertisement

Quick Links

Download this manual
EPILOG LASER
16371 Table Mountain Parkway
Golden, Colorado 80403
Phone 303-277-1188 - FAX 303-277-9669
Tech@epiloglaser.com
www.epiloglaser.com
Procedure Title:
Machine Type:

Tools Needed:

WARNING:

o UNDER NO CIRCUMSTANCES ARE YOU TO ATTEMPT TO
OPERATE THE FIBERMARK LASER ENGRAVER WITH THE SIDE
PANELS REMOVED. SERIOUS and PERMANENT EYE DAMAGE
MAY OCCUR.
o LEXAN SAFTEY GLASSES WILL NOT PROTECT YOUR EYES FROM
THE FIBERMARK'S LASER BEAM.
 THE FIBER OPTIC CABLE IS VERY DELICATE.
 DAMAGE TO THE OPTICAL FIBER IS NOT COVERED BY THE MANUFACTURERS
WARRANTY.
 DAMAGE TO THE FIBER OPTIC CABLE IS A $3000.00 (USD) REPAIR.
 NEVER BEND THE FIBER OPTIC CABLE TIGHTER THAN A THREE INCH RADIUS.

Fiber Laser Replacement

FiberMark Laser Engraver
#1 Phillip's Screwdriver

NOTICE

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the FiberMark and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for Epilog Laser FiberMark

Summary of Contents for Epilog Laser FiberMark

  • Page 1 #1 Phillip’s Screwdriver WARNING: o UNDER NO CIRCUMSTANCES ARE YOU TO ATTEMPT TO OPERATE THE FIBERMARK LASER ENGRAVER WITH THE SIDE PANELS REMOVED. SERIOUS and PERMANENT EYE DAMAGE MAY OCCUR. o LEXAN SAFTEY GLASSES WILL NOT PROTECT YOUR EYES FROM THE FIBERMARK’S LASER BEAM.
  • Page 2 1. Disconnect the machine from the power source. 2. Using the #1 Phillip’s Head Screw driver remove the rear panel from the machine. 3. There are five electrical connections from the power supplies that must be de-mated and one ribbon cable that must be disconnected from the laser before it can be removed. If the connections can’t be removed at this time because they are hidden from view by the laser, they may be disconnected after step 10 when the laser is removed from the chassis.
  • Page 3 6. As you remove the last Allen Screw, hold the optical isolator/combiner in your free hand. DO NOT ALLOW the isolator/combiner to drop out of the mount. Carefully set the isolator/combiner off to the right hand side of the machine. 7.
  • Page 4 12. Position the replacement laser assembly at the rear of the FiberMark laser engraver. 13. Reconnect the five Electrical connections and the one ribbon cable to the laser/power supply assembly. 14. Lift the laser and gently set it on the mounting pins attached to the rear of the machines chassis.

Table of Contents