Epilog Laser FiberMark Replacing

EPILOG LASER
16371 Table Mountain Parkway
Golden, Colorado 80403
Phone 303-215-9171 - FAX 303-277-9669
www.epiloglaser.com
Procedure:
Machine Type:
Tools Required:
NOTE: Your replacement controller board was shipped to you in an anti-
static bag to protect the controller board from being damaged by static
electricity.
Do not handle the controller board without wearing the included
anti static strap.
Place the defective controller board in the anti-static bag before
returning it to Epilog.
NOTE: If the machine will still boot, before you remove the board please
follow steps 1 and 2. This will save you a lot of set up time when the
new board is installed.
If the board will not boot up skip to step 4, the controller board
that you have been sent has been programmed with the settings that were
used to set your machine up originally.
1. If the machine will still boot up, before you remove the
controller board, please record the following information from
the Function and Configuration menus of the machine. To access
the function menu in the engraver depress both the "GO" and
the "Pointer" buttons on the display.
2. From the Configuration menu you will need to record the
following information.
Replacing the Controller Board
FiberMark
Phillips head screw driver
Serial Number
IP Address
Subnet Mask
Gateway
X-Home
Y-Home
XR Home
YR Home
Laser Match
System unit