Epilog Laser Fusion Maker Manual page 11

17000 - CO2 Laser Alignment
5. Inspect the location of the red dot in
relation to the center of the alignment
target. If the red dot pointer is not in
the center of the alignment target,
adjustments will need to be made to
mirror 4:
6.
7.
8.
9.
10.
11.
12.
13.
14.
15.
16.
Mirror 4 Adjustment Guide
17. Adjust the red dot location so that it is
centered on the alignment target.
18. Raise the table while watching the
location of the red dot. If the red
dot moves off of the center of the
alignment target, repeat this process,
until there red dot does not change
position when raising or lowering the
table.
If further assistance is required, contact
Epilog Laser Technical Support by phone
at 303-215-9171, or by email at
tech@epiloglaser.com
11