Epilog Laser Fusion Maker Manual page 5

17000 - CO2 Laser Alignment
Table Positions Mirror 2 / Position 2
Mirror 3 / Positions 3 & 4
There are four (4) mirrors in the Fusion Pro
CO2-only engraver, all of which may need
to be adjusted while aligning the cutting
laser.
Each of the mirrors in the Fusion Pro
engraver are referenced by number in
this procedure and correspond to a
specific table location. When adjusting
a mirror, ensure that the correct one is
being adjusted for that specific table
location.
Mirror Locations, Numbers, and
Corresponding Table Position
Mirror 4/Perpendicular Alignment
Mirror 1 / Position 1
5