Epilog Laser Fusion Maker Manual page 8

17000 - CO2 Laser Alignment
Adjusting Mirror/Position 1
1. Place a new piece of masking tape on
the alignment target.
2. Ensure that the red dot pointer is
activated.
3. In Alignment Mode, press Top Left to
move the lens carriage to the top left
corner (position 1) of the engraver.
4. Inspect the location of the red dot in
relation to the center of the alignment
target. If the red dot pointer is not in
the center of the alignment target,
adjustments will need to be made to
mirror 1.
5. Remove the lower mirror cover at the
back left corner of the engraver:
6. Adjust the red dot position so it is
centered on the alignment target
using the three (3) Allen adjustment
screws located on the back of mirror 1:
Mirror 1 Adjustment Screw Guide
Adjusting Mirror/Position 2
1. Ensure that the red dot pointer is
activated.
2. In Alignment Mode, press Bottom
Left to move the lens carriage to the
bottom left corner (position 2) of the
engraver.
3. Inspect the location of the red dot in
relation to the center of the alignment
target. If the red dot pointer is not in
the center of the alignment target,
adjustments will need to be made to
mirror 2.
8