Advanced Functions; Chime; Omitting Zones; Keypad Pa - Pyronix Enforcer X Series User Manual

ADVANCED FUNCTIONS

CHIME

The chime can be used for any zone on the system. This can be
programmed by your installation company.
To enable the chime on the keypad, when the time is displayed,
press c.
Press c again to cycle through 'c' , 'C' and nothing.
Cycle Display
Nothing N/A
Lower case c c
Capital c C

OMITTING ZONES

On occasion, a detector may need to be isolated if a room is
occupied.
Start the arming procedure.
Once the exit timer is on the display, press f.
Select the zones that need to be omitted.
Press h.
After 10 seconds the exit time continues.
Please note: Zones have to be programmed as omittable by your installation company for this feature to operate.

KEYPAD PA

A 'panic' alarm will be generated when 1 and 7 are
pressed and held down for 2 seconds. This feature, along with the
length of time required for the keys to be pressed, are programmed
by the installation company.
Please note: The keyfob can also be programmed to initiate a panic alarm. All panic alarms including duress codes
must be enabled by the installation company.
Chime Noise
Silent
Chime from keypad
Chime from keypad and speakers on
the system
ENFORCER X USER GUIDE
Alarm Panel
Time 10:09 c
Omit Zone?
Z1
Alarm Silenced
2 Key PA
13