Energy Storage Safepos Energy-Pack (Option) - Burkert 3363 Operating Instructions Manual

Electromotive diaphragm control valve
Hide thumbs Also See for 3363:
Table of Contents

Advertisement

Fig. 8:
Schematic presentation of the process control
7.3

Energy storage SAFEPOS energy-pack (option)

The device can also be equipped with the energy storage system (SAFEPOS energy-pack). In the event of a
supply voltage failure, the energy storage system supplies the actuator with the energy required to move the
valve to the safety position.
The safety position is set using the DIP switch.
After a maximum of 120 seconds (depending on operating conditions), the energy storage is fully charged
and ready for operation.
7.3.1
Service life
Service life: up to 15 years (depending on operating conditions).
The service life of 5 years was calculated based on the following conditions:
Ambient temperature
Medium temperature
Duty cycle
Medium pressure
Nominal diameter
ATTENTION!
The energy storage system SAFEPOS energy-pack is a wearing part. The service life figures are appro-
ximate values that cannot be guaranteed.
7.3.2
Notifications on the state of the SAFEPOS energy-pack
The device issues a warning:
the energy storage system capacity is greatly reduced. The energy storage system must be replaced soon.
The SAFEPOS energy-pack must be promptly replaced before the end of its service life.
The device issues an error alert and assumes the safety position:
The SAFEPOS energy-pack was not promptly replaced before issuance of the warning. The storage
capacity is so low that assumption of the safety position can no longer be guaranteed.
7.3.3
Replace SAFEPOS energy-pack (AG2)
CAUTION!
Risk of injury from electrical voltage.
▶ Turn off the supply voltage before removing the SAFEPOS energy-pack.
▶ Ensure that the SAFEPOS energy-pack is fully discharged. Wait until the LED light ring is no longer lit and
ensure that the LED status is not in "LED off"
The SAFEPOS energy-pack is located in the actuator housing. Remove the following parts from the actuator
for replacement:
27
30 °C (AG2) / 65 °C (AG3)
165 °C
100%
5 bar
DN32 (AG2) / DN65 (AG3)
mode
English
Typ 3363, 3364, 3365
Control electronics
(see chapter "12.2.1 LED illuminated ring").

Advertisement

Table of Contents
loading

This manual is also suitable for:

33643365Ae3363Ae33

Table of Contents