Commissioning - Beckhoff CP6706-0001 Manual

Commissioning

4 Commissioning
In order to use the panel PC, you must first commission it. The first step is to transport the device to is
operating location and unpack it. This is followed by installing the device in the control cabinet front,
connecting the cables and the power supply and finally switching on the panel PC.
Operating the device
The device is operated via the touch screen.
Damage to the touch screen
Operating the touch screen with unsuitable objects may damage the touch screen.
• Operate the touch screen only with bare fingers or wearing suitable gloves.
• If you use gloves, make sure that no hard particles such as metal shavings, glass splinters or similar
adhere to the glove.
If you, as the user, require additional protection for the touch screen against dirt and scratching, for example
due to dirty hands, this can be achieved with a Beckhoff protective film. The film provides short-term
protection for a few days.
You can either order a Beckhoff protective film individually and fit it yourself retrospectively, or you can order
the film for fitting directly ex factory. Please refer to the price list for the available protective films according to
the display size of your device.
Proceed as follows to attach the protective film to the touch screen:
1. Ensure that the environment is as dust-free as possible.
2. Thoroughly clean the surface of the device to be fitted with the film and remove all grease residues.
3. Detach the film from the backing at the short edge and place it on the surface.
4. Gradually remove the film from the backing. At the same time, use a doctor blade or other object with a
soft rubber or felt edge to apply the film.
5. Brush away air bubbles towards the edge with a doctor blade or other object with a soft rubber or felt
edge.
ð The film is now fitted.
If you want to remove the protective film again, you must proceed with caution so as not to damage the
touch foil, which is located between the glass pane of the panel PC and the applied protective film.
To remove the protective film, proceed as follows:
1. Carefully loosen one corner of the protective film.
2. Carefully pull the protective film off the control panel at the loosened corner at as flat an angle as
possible.
ð You have removed the protective film.
18
NOTICE
Version: 2.0 CP6706-0001