Commissioning - Beckhoff CP77 Series Manual

Commissioning

4 Commissioning
In order to use the panel PC, you must first commission it. The first step is to transport the device to is
operating location and unpack it. This is followed by the installation of the device on the wall or mounting
arm, the connection of the cables and the power supply and finally the switching on of the panel PC. Since
the panel PC does not have its own power switch, switching the power supply on and off also switches the
panel PC on and off.
Operation of the panel PC
Damage to the touch screen
Operating the touch screen with unsuitable objects may damage the touch screen.
• Only operate the touch screen with your bare finger or with your finger using a suitable glove.
• If you use gloves, make sure that no hard particles such as metal shavings, glass splinters or similar
adhere to the glove.
If you, as the user, require additional protection for the touch screen against dirt and scratching, for example
due to dirty hands, this can be achieved with a Beckhoff protective film. The film provides short-term
protection for a few days.
You can either order your device directly with the protective film applied or order a film individually and apply
it yourself.
Please refer to the price list for the available protective films according to the display size of your device.
Proceed as follows to attach the protective film to the touch screen:
1. Ensure that the environment is as dust-free as possible.
2. Thoroughly clean the surface of the device to be fitted with the film and remove all grease residues.
3. Detach the film from the backing at the short edge and place it on the surface.
4. Gradually remove the film from the backing. At the same time, use a doctor blade or other object with a
soft rubber or felt edge to apply the film.
5. Brush away air bubbles towards the edge with a doctor blade or other object with a soft rubber or felt
edge.
ð The film is now fitted.
If you want to remove the protective film again, you must proceed with caution so as not to damage the
touch foil, which is located between the glass pane of the panel PC and the applied protective film.
To remove the protective film, proceed as follows:
1. Carefully loosen one corner of the protective film.
2. Carefully pull the protective film off the panel PC at the loosened corner at as flat an angle as possible.
ð You have removed the protective film.
You can use the Dimming, Screensaver and Cleaning mode functions with the Display Control Tool. The
Beckhoff Information System provides more information about the tool: https: //infosys-cdn.beckhoff.com/
content/1033/panelconfigurationtools/11725543179.html?id=1863235424645236061.
18
NOTICE
Version: 3.4 CP77xx