W Hat To Do In The Event Of A Fault; Power Cut; Demo Mode - Gaggenau BOP 210 1.2 Instruction Manual

en
What to do in the event of a fault

W hat to do in the event of a fault

3
M alfunctions often have simple explanations. Please
W h a t t o d o i n t h e e v e n t o f a f a u l t
read the following notes before calling the after-sales
service.
Disruption
Appliance not working, no display
Appliance cannot be started
The appliance is not working and the
display does not respond.
the display
Appliance switches off on its own
Appliance does not heat up, ° appears
in the display
Error message "Exxx"

Power cut

Your appliance can bridge a power cut of a few
seconds. Operation continues.
If the power cut was for a longer period and the
appliance was in operation, a message appears in the
display. Operation is interrupted.
Set the function selector to 0, then the appliance can be
operated again as usual.
28
Possible cause
Plug not inserted
Power failure
Fuse defective
Operating error
Appliance door is not quite closed
Childproof lock activated
0
appears in
Safety shut-off: the appliance has not
been operated for longer than 12 hours
Appliance is in demo mode
m
Warning – Risk of electric shock!
Incorrect repairs are dangerous. Repairs may only be
carried out and damaged power cables replaced by one
of our trained after-sales technicians. If the appliance is
defective, unplug the appliance from the mains or switch
off the circuit breaker in the fuse box. Contact the after-
sales service.
Solution
Connect the appliance to the electricity
mains
Check whether other kitchen appliances
are working
Check in the fuse box whether the fuse for
the appliance is in working order
Switch off the fuse for the appliance in the
fuse box and switch it on again after about
60 seconds
Close appliance door
Deactivating the childproof lock
"Childproof lock" on page 20
~
Confirm the message with ™, switch off the
appliance and set it again.
Deactivate the demo mode in the basic set-
tings
If an error message is displayed, turn the
function selector to 0; if the display goes
out, there was a non-recurring problem. If
the error occurs repeatedly or the display
remains on, please contact the after-sales
service and inform them of the error code.

Demo mode

The ° symbol appears on the display when the
appliance is in demo mode. The appliance will not heat
up.
Briefly disconnect the appliance from the mains (switch
off the household fuse or the circuit breaker in the fuse
box). Then deactivate demo mode in the basic settings
"Basic settings" on page 24
within 3 minutes. ~