Table of Contents
Advertisement
en
Operating the appliance
O perating the appliance
1
C ooking compartment
O p e r a t i n g t h e a p p l i a n c e
m
Warning – Risk of scalding!!
The inside of the appliance door becomes very hot
during operation. Always open the appliance door as far
as it will go. Ensure that the appliance door does not
swing back. Avoid contact with the inside of the
appliance door.
The cooking compartment has four shelf positions. The
shelf positions are counted from the bottom up.
Caution!
–
Do not place anything on the cooking compartment
floor. Do not cover it with aluminium foil. A build-up
of heat could damage the appliance.
–
Do not slide any accessories between the shelf
positions, or they may tip.
Inserting accessories
The accessories have a locking function.The locking
function prevents the accessories from tilting when they
are pulled out.The accessories must be inserted into the
cooking compartment correctly for the tilt protection to
work properly.
When inserting the wire rack, make sure that
the lug ¨ is pointing downwards
▯
the safety bar © on the wire rack is at the back and
▯
on top.
14
Switching on
1
Set the required heating mode using the function
selector. The chosen heating mode and the default
temperature are displayed.
2
If you want to change the default temperature:
set the required temperature with the rotary
selector.
The preheating symbol
bar continuously shows the preheating status. When the
set temperature is reached, a signal sounds and the
'
preheating symbol
goes off.
Note: The oven interior lighting stays switched off at a
temperature setting below 70°C
Switching off:
Turn the function selector to 0.
Rapid heating
With the "Rapid heating" function, your appliance
reaches the temperature you require particularly quickly
in the "top heat", "bottom heat" and "top+ bottom heat"
types of heating.
To ensure an even cooking result, do not place your
food in the cooking compartment until "Rapid heating"
is complete and the heat-up symbol
Note: The "Rapid heating" function is preconfigured in
the factory settings. You can select "Rapid heating"
"
or "Heat-up"
in the basic settings.~
settings" on page 24
Safety shut-off
For your protection, the appliance is equipped with an
automatic safety shut-off. Any heating process is
switched off after 12 hours if the oven is not operated in
this time. A message appears in the display.
Exception:
The long-term timer has been programmed.
Set the function selector to 0, then the appliance can be
operated again as usual.
'
appears on the display. The
'
has gone out.
"Basic
'
Advertisement
Chapters
Table of Contents
