Installation; About Inspection; About Host Software - Magtek DynaFlex II Go Installation And Operation Manual

4 - Installation

4 Installation
Installing DynaFlex II Go products is straightforward: The manufacturer or acquirer, configures the
preferred settings, keys, terminal, and payment brand settings before deployment; end users need only set
up a host with appropriate software, configure the software, and connect the device to the host. This
section provides general information about inspecting, connecting, and installing DynaFlex II Go
products.
4.1

About Inspection

Before unpacking the device, it is important to inspect its secure packaging to make sure it has not been
tampered with in storage or in transit. MagTek provides details for inspecting the integrity of the device's
secure packaging in D998200594 DynaFlex II Go Package Inspection Document.
It is important to thoroughly inspect a new device before deployment, and regularly inspect devices in
live usage (including its immediate surroundings) to make sure malicious individuals have not tampered
with it. MagTek recommends conducting inspection training for all device operators, and an inspection
schedule with checkpoints in place to make sure operators are performing inspections as specified and as
scheduled. MagTek provides an easy-to-follow device inspection reference D998200593 DynaFlex II
Go Device Inspection Document.
4.2

About Host Software

DynaFlex II Go products do not have a display. In any solution, DynaFlex II Go must be connected to a
host, which must have software installed that can communicate with the device and is capable of
processing transactions. To set up the host to work with DynaFlex II Go, follow the installation and
configuration instructions provided by the vendor of the host or the host software. For information about
developing custom host software, see section 9 Developing Custom Software.
DynaFlex II Go| EMV Contactless/NFC Card Reader | Installation and Operation Manual
Page 11 of 55 (D998200595-100)