Usb Enumeration - Magtek DynaFlex II Go Installation And Operation Manual
Emv contactless/nfc card reader
Hide thumbs
Also See for DynaFlex II Go:
- Programmer's manual (301 pages) ,
- Manual (18 pages) ,
- Document (2 pages)
Table of Contents
Advertisement
7 - Introduction to User Interface
7.3
USB Enumeration
When DynaFlex II Go is connected via USB in an idle state, it can be detected by a host through the USB
HID port see Figure 7-6. After the host has connected to DynaFlex II Go, LED 1 and 2 will stay on. The
device is in Ready State.
Figure 7-6 - LED Status (Idle State) Before Host Detection and LED Status (USB Ready State) After
Connecting to Host
DynaFlex II Go| EMV Contactless/NFC Card Reader | Installation and Operation Manual
Page 24 of 55 (D998200595-100)
Advertisement
Table of Contents
Need help?
Do you have a question about the DynaFlex II Go and is the answer not in the manual?
Questions and answers