How To Connect Dynaflex Ii Go To A Windows 10 Host [Version 1703 Or Above] Via Bluetooth Le (Windows Drivers) - Magtek DynaFlex II Go Installation And Operation Manual

4 - Installation
4.3.4 How to Connect DynaFlex II Go to a Windows 10 Host [Version 1703 or Above] via
Bluetooth LE (Windows Drivers)
To connect DynaFlex II Go to a host with Windows 10 version 1703 or above, and Bluetooth 4.0 or
higher hardware that supports Bluetooth LE, follow these steps:
1) Make sure the host's Bluetooth interface is turned on and working correctly.
2) If any Bluetooth LE host software has an active data connection to the device, close the connection.
1. On the host, install and configure the software you intend to use with DynaFlex II Go (if you do not
yet have that software, you can use 1000007351 MagTek Universal SDK for MMS Devices
(Windows) available from MagTek.com, to perform simple tests):
a) Make sure the host software is configured to look for the device on the proper connection type.
b) Make sure the host software knows which device(s) it should interface with.
c) Make sure the host software is configured to properly interpret incoming data from the device.
When using Bluetooth LE, the device transmits data in GATT format.
3) Make sure the DynaFlex II Go output connection is configured to transmit card data over Bluetooth
LE. This is the factory default.
4) In the menu type
Start
click the
Bluetooth Devices
settings window.
5) Locate the seven-digit serial number on the label on the bottom of the device.
6) Press and hold the
Power Button
Pairing is in process. The Bluetooth Status LED flashes once per second for up to three minutes, or
until a host pairs or connects.
7) Press the
Add Bluetooth or other device
8) Under Choose the kind of device you want to add
9) Read through the list of pairable devices and locate the device called
does not match the device's serial number. The Bluetooth LE name has a maximum length
xxxxxxx
of 20 characters. Select the device. Enter the configured passkey (or the default
the button.
Connect
10) After a short period of time, the text
Note that in this case, "Connected" means the device is paired, but the host does not have an active
data connection until the host software initiates one.
11) Press the button to close the
Done
12) Use the host software to test swiping a card.
13) Remember to change the default password. See the DynaFlex II Go Programmer's Reference
documents for details.
To unpair from the device:
1) Select the device in the
DynaFlex II Go| EMV Contactless/NFC Card Reader | Installation and Operation Manual
and select
Bluetooth Bluetooth and other devices settings
icon in the taskbar to launch the
for 4 beeps until LED 4 starts flashing indicating Bluetooth
button to launch an
Connected
Add a device
Bluetooth and other devices settings
Page 16 of 55 (D998200595-100)
Bluetooth & other devices
Add a device
, select Bluetooth
DynaFlex-xxxxxxx
appears below the device you are pairing with.
window.
window.
, or double-
window.
.
, where
) and press
999999