How To Scan Barcodes - Magtek DynaFlex II Go Installation And Operation Manual

7 - Introduction to User Interface
Figure 7-30 – Contactless Read LED Sequence – Read Complete (Connected via Bluetooth LE)

7.9.3 How to Scan Barcodes

To scan a barcode, follow these steps:
1) Make sure you are using a DynaFlex II Go model that includes a barcode reader, indicated by QR
Code markings on the face of the device surrounding the barcode reader lens (see section 1.1 Key
Features and Components).
2) If the barcode being scanned is not on a self-illuminated source such as a smartphone, make sure
there is enough ambient light for the camera to read the barcode. In low light conditions, the barcode
reader will only be able to read self-illuminated sources.
3) In some solutions, the operator may have to perform an operation in the host software to enable the
barcode reader, or to start a transaction with the barcode reader enabled.
DynaFlex II Go| EMV Contactless/NFC Card Reader | Installation and Operation Manual
Figure 7-29 - Tapping a Contactless Card / Smartphone
Page 40 of 55 (D998200595-100)