Quectel EM160R-GL Hardware Design page 6

Updated the description about EVB (Chapter 2.4).
Added the ripple and VBAT data in the figure of power supply limits (Figure 3).
Updated the turn-on and turn-off timing information (Chapters 3.4.1.1 and 3.4.2.1).
Deleted the information about turning off the module through AT command.
Updated the module reset information (Chapter 3.5).
Changed pin 24 into VDDIO in the table of PCM interface pin (Table 13).
Deleted the figure of PCIe turn-on timing requirements of M.2 Specification.
Updated the figure of thermal dissipation area on bottom side of the module (Figure 33).
Deleted the related information of EM120R-GL.
Updated the PCIE_REFCLK in turn-on timing (Figure 7).
Updated the PCIE_REFCLK and CLKREQ# in timing of resetting the module (Figure 11).
Updated the PCIe Interface Reference Circuit (EP Mode) (Figure 16).
Updated the PCIe D3 Cold State Timing (Figure 17).
Updated reference circuit of DPR (Chapter 3.9.5).
1.3.0 2023-06-05
Updated configuration of config pins (Figure 24 and Table 24).
Added B29/B32/B46 in Rx Sensitivity (Chapter 4.1.2).
Remove the type Compass in GNSS frequency (Chapter 4.2).
Updated the data in GNSS performance (Table 35).
Updated the top view of the module (Chapter 6.2).
Added the description of module installation (Chapter 6.4).
Updated packaging specifications (Chapter 6.5).
Added a note to the host in the procedure of turning on (Chapter 3.4.1).
1.3.1 2023-07-15
Updated the pulling down time of RESET# (Chapter 3.5).
Updated the time of T1 in the turn-off procedure (Table 9).
1.3.2 2023-09-01 Updated the timing of RESET# (Table 11).
EM160R-GL_Hardware_Design
To meet the specific demanding of Lenovo.
To prevent module unrecognition problems caused by incorrect reference clock timing.
To prevent module unrecognition problems caused by incorrect reference clock timing.
To prevent module unrecognition problems caused by incorrect GPIO configuration
during host turn-on.
The timing of the wake-up control signal is provided to the customer, which more
intuitively shows the process of the module from D3cold to D0 state.
To prevent customers from directly connecting, which may cause the module to fail to
work properly.
To meet the specific demanding of Lenovo.
To add the data of Rx only.
To follow the specification of EM160R-GL.
To add the data of GNSS performance.
Follow Quectel standard.
To remind customers to assemble correctly so as to make sure the normal operation of
the module.
Follow Quectel standard.
To remind customers not to drive RESET# low after FULL_CARD_POWER_OFF# is
de-asserted at booting stage so as to turn on successfully.
To meet the specific demanding of Lenovo.
To disable PCIe interface successfully by asserting PERST#.
To meet the specific demanding of Lenovo.
LTE-A Module Series
Iyukee SHEN/
Lewis PENG
Iyukee SHEN
Iyukee SHEN
Iyukee SHEN
Iyukee SHEN
Iyukee SHEN
Iyukee SHEN
Lewis PENG
Lewis PENG
Lewis PENG
Iyukee SHEN
Iyukee SHEN
Iyukee SHEN
Fung ZHU
Fung ZHU
Fung ZHU
Fung ZHU
5 / 73