Showven SPARKULAR Cyclone BT61 User Manual page 9

e) Assign DMX address for each unit of SPARKULAR
or FXcommander to control the machine please allocate a unique DMX address for each
unit of machine.
f) Connect a DMX cable to the DMX IN socket of first unit of SPARKULAR
the male connector end of DMX cable to your DMX controller (FXcommander, HOST
CONTROLLER, light console etc).
g) Connect a DMX cable to the DMX OUT of previous machine, and the other end of to the
DMX IN of next machine. Connect all devices in series in this way.
h) Suggest to plug in a DMX terminator into the DMX OUT in last unit of machine to improve
signal reliability. Signal amplifier is required for long distance (>200m) DMX signal
transmission.
4. Activate SPARKULAR
a) Swipe an RFID card. Read the card as show below. SPARKULAR
if read successfully.
®
b) SPARKULAR Cyclone will report E4 when remaining time is less than 10 minutes.
c) Please note each RFID card come with 200g package HC8200 can increase single machine
10min working time, the maximum recharge time each time for SPARKULAR
30min, when time remain reached 30min, it can't recharge anymore RFID card.
C N . 00000001
5. Programming and Firing
a) Programming SPARKULAR
b) Heating up machine, it takes around 5min. it various according to the voltage and
environment temperature.
c) Make sure the prescribed safety zone is clear.
d) Suggest to clear material before firing.
e) Firing. In order to prevent overheat in the heating chamber and protect machine, the
maximum continuous firing time for SPARKULAR
f) The operator should always have a clear view of the device, so that he/she can stop the
show immediately when there is danger.
g) Clear material for SPARKULAR® Cyclone for 5s after show, clear material will remove the
remaining particles from heating chamber. For angled installation, please elongate clear
material time.
6. Turn off and Clean up
a) Power off SPARKULAR
®
Cyclone by swipe RFID card
®
Cyclone, set the firing height, firing sequences etc.
®
II, allow SPARKULAR
®
Cyclone. If use SHOWVEN host controller
®
Cyclone shows time remain
®
Cyclone is 30s.
®
Cyclone to cool down.
®
Cyclone, connect
®
Cyclone is