Showven SPARKULAR Cyclone BT61 User Manual page 7

Density@ Height 1
Density@ Height 2
Density@ Height 3
Density@ Height 4
Density@ Height 5
Density@ Height 6
Density@ Height 7
Density@ Height 8
Density@ Height 9
Density@ Height 10
Factory Mode
Mode Selection
/ User Mode
2 / 4 / 2+3
DMX Channel
Braking
Standby Switch
For better performance of SPARKULAR
without permission from SHOWVEN
5. DMX Control
®
SPARKULAR Cyclone occupy 2 channels.
First channel
0-15
16-255
Second channel
60-80
20-40
0-10
240-255
Operation Guide
Δ
1. Install SPARKULAR
a) Horizontal installation is preferred for SPARKULAR
®
SPARKULAR Cyclone in angles, maximum firing angle is 45 ° and can only be angled to the
right side as below picture.
14-90 80
14-90
80
14-90
80
14-100
80
14-100
80
14-100
80
14-100
80
14-100
90
14-100
100
14-100
100
User Mode
2 DMX
DMX
Channel
Channel
ON/OFF OFF
ON/OFF OFF
®
Cyclone, please don't change the default value
®
.
Pre-heat OFF (disabled when auto-heat ON)
Pre-heat ON (disabled when auto-heat ON)
®
Cyclone
Sparks density @ Height gear 1
Sparks density @ Height gear 2
Sparks density @ Height gear 3
Sparks density @ Height gear 4
Sparks density @ Height gear 5
Sparks density @ Height gear 6
Sparks density @ Height gear 7
Sparks density @ Height gear 8
Sparks density @ Height gear 9
Sparks density @ Height gear 10
Factory mode is for engineer only. When in
Factory mode machine can't controlled by DMX
console/host controller
Don't change. 4 DMX Channel and 2+3 DMX
Channel are for special use.
When ON, blower motor will auto brake when
stop firing, frequent braking will leads to over
temp.
When ON, the machine can firing only when
heating up was finished
Function
Firing OFF
Firing ON and with adjustable height
Function
Clear Material
Emergency Stop
®
Cyclone. If need to installed