Replacing The Batteries/Fuse Vrla Agm 17Ah - Pronomic Lift & Drive 90PRX Operator's Manual

7.3

Replacing the batteries/fuse VRLA AGM 17Ah

+24V
WARNING:
Make sure that no charger is
connected to the battery unit.
WARNING:
Caution when handling the
batteries and their terminals.
For fuse replacement only follow numbers 1-6
1. Place the battery unit securely on a table.
2. Open the battery enclosure by loosening the four
screws of the right gable enclosure. Leave the
cables connected to the gable enclosure.
3. Remove the short side fixing plate by loosen its
screw.
4. Remove the long side fixing plate. Carefully slide
out the batteries from the battery
5. enclosure.
30
7
Electrical hazard!
Electrical hazard!
5
6
4
3
-0V
6. Detatch the cables from the batteries.
7. Disconect the fuse by the two screws.
For fuse replacement, replace the fuse.
Reconnect cables figure 5.
Remount by
follow numbers 4-2).
Remove the old batteries.
Arrange the new batteries with the
contacts facing same direction.
Connect the fuse in figure 6 and cables in figure 5
to the new batteries.
Remount by follow figure 4-2.
8. WARNING Avoid short circuit, keep distance be-
tween batteries terminals.
1
2