Basic Function Tests; Testing The Brakes - Pronomic Lift & Drive 90PRX Operator's Manual

WARNING:
personnel cannot trip over the
trolley or its connected cables.
WARNING:
dry and ventilated space when
charging the power pack.
The battery unit must be charged for min. 8 hours
before performing basic function tests.
1. Engage the central brake. If battery will be charged
when stand alone; refer to chapter 5.2 "Remove
the battery unit from trolley".
2. Connect the 4-pin plug to the battery unit.
3. Connect the 2-pin male plug to the wall socket. The
indicator lamp on the charger turns orange if the
battery unit is not fully charged. The indicator lamp
turns green when the battery unit is fully charged.
Disconnect the charger from the battery unit be-
fore using the lift trolley.T
16
Make sure that
Position the lift trolley in a

4.3 Basic function tests

4.3.1 Testing the brakes

The brake rod has 3 positions:
• Lowest position – central brake
• Middle position – disengaged/unlocked
• Upper position – directional lock