Table of Contents
Advertisement
6 Maintenance
6.1
Periodic maintenance
WARNING:
there is suspicion of damaged or faulty
components.
Periodic maintenance should be carried out every year,
or when needed.
Always replace broken or suspected broken parts. Use
parts supplied and approved by Pronomic.
If needed contact your supplier for advice.
6.1.1 Preparations before maintenance
•
Make sure the battery charger is not connected to
the lift trolley.
•
Park the lift trolley where there is good light and
room to walk around the machine to do visual
inspections.
•
Engage the central brake.
6.1.2 Cleaning the lift trolley
CAUTION
water to clean the lift trolley.
Clean the lift trolley using detergent suitable for paint-
ed surfaces, aluminum and stainless steel. Follow the
instructions on the detergent.
Wipe the lift trolley dry after cleaning.
Do not use hose or high-pressure jet as this may
damage the electronics and the paint.
Clean the lift trolley using detergent suitable for
painted surfaces, aluminum and stainless steel.
Follow the instructions on the detergent. Wipe the lift
trolley dry after cleaning.
Do not use hose or high-pressure jet as this may
damage the electronics and the paint.
Do not use the lift trolley if
: Do not use running
6.1.3 Checklist maintenance
•
Mechanical parts
Check the mechanical parts of the lift trolley for
wear and cracks.
•
Electrical connectors
Remove the battery unit from trolley; refer to
chapter 5.2 "Remove the battery unit from trolley".
Check all the electrical connectors and visible wires
for wear and tear. If dirty remove in a safe manner.
•
Nuts and bolts
Make sure all nuts and bolts are tightened.
•
Brakes
Check the brakes are working. Refer to chapter
4.3.1 "Testing the brakes" for further
instructions.
•
Wheels
The condition of the wheels is important due to
ergonomic. Make sure all wheels roll
normally and smoothly. Remove dirt and other
debris between wheel and castor. Inspect the
castors and the tire rubbers on the wheels for wear
and tear.
•
Knobs
Knobs for handlebar and bracket to the hand
control Check the knobs can be loosen and tighten
properly.
•
Lift column
Clean the brush stripes and wipe the column clean.
•
Battery maintenance
Ask the operator who normally uses the
if it holds the charge or if it needs to be charged
during the work shift.
Check the chapter 7 "Battery unit
performance".
6.1.4 Tests
Perform all function tests refer to chapter 4.3 "Basic
function tests" before the lift trolley is put back into use
again.
trolley
27
Advertisement
Table of Contents
