Table of Contents
Advertisement
4.1.3 Ordered and delivered as partially assembled Model 175/225 PRX
3
4
1
WARNING:
Always wear protective shoes when oper-
ating the lift.
1. Place the chassis of the trolley on the floor. Engage
the central brake.
2. The bracket with two T-slots of the top of the
column. T-slots runs along the entire back of the
column
3. The upper cross-member bracket with two T-slot
bars. On delivery this bracket is fixed to the cross-
member.
4. The lower cross-member bracket. On delivery this
bracket is fixed to the column. Mounting: Slide the
T-slots on the back of the column into the upper
bracket on the cross-member. Place the column
with the cross-member bracket on the cross-
member.
14
2
14
×4
12
13
×3
Heavy load!
6
10
15
11
8
5
5. On delivery, the control unit are attached to the
mounting shelf. Slide the shelf into the T-slot on
the back of the column.
6. The cable from crossmember to the electrical
control unit determines the height of the shelf with
the control unit. Connect the contact, secure with
its toggle lock. Make sure the cable is straight.
7. Fix the shelf with four screws.
8. Slide the handlebar into the T-slot on the back of
the column. Use the knob to lock the handlebars at
the desired height.
9. The battery unit will be placed under the electrical
control unit on the shelf. Lift the battery unit by the
handles at each gable of the battery unit. Angle the
far and bottom side of the battery unit towards the
holder.
Then slide the battery in. Release the
handles.
9
7
×4
Advertisement
Table of Contents
