First Time Charging - Pronomic Lift & Drive 90PRX Operator's Manual

(To remove the battery unit; refer to chapter 5.2
"Remove the battery unit from trolley").
10. Insert the hand controller into its holder. Connect
the cable from the hand control to the control unit.
11. Push the lever down on the hand control to make
the column go down to its lowest position.
12. The column should stand directly on the
cross-member.
13. Use 5mm hex key to tighten the three countersunk
screw on the lower cross-member bracket,15 Nm.

4.2 First time charging

3
14. Use 13 mm wrench to tighten the four nuts on the
15. Attach the tool to the load carrier.
Note, once the column has been mounted/remounted
perform the static load test, chapter 4 "Set up".
2
2
A
3
1
upper cross-member bracket,15 Nm.
15