Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Pronomic Lift&Drive 20205B
Summary of Contents for Pronomic Lift&Drive 20205B
- Page 1 Lift trolley Lift&Drive 20205/20205B Original instructions...
- Page 2 It is important that you read and understand the manual before using the lift trolley. Do you have any questions? – Please contact the distributor or the manufacturer. Pronomic AB Visiting address: Postal address: Bäckvägen 18 Box 5504 192 54 Sollentuna...
-
Page 3: Table Of Contents
Contents Description of the lift trolley ....................1 Warranty ............................1 Components ..........................1 Assembly ..........................3 Disassembly and scrapping ......................3 Using the lift trolley ......................4 Handlebar ............................ 4 Remote control ..........................4 Power pack ..........................5 Brakes ............................5 Directional lock .......................... -
Page 4: Description Of The Lift Trolley
Damage due to misuse or incorrect use of the equipment will void the warranty. 1.2 Components The lift trolley consists of a number of modules. The locations of these are shown in the image on the next page. Please contact Pronomic for information regarding part numbers. ... - Page 5 ________________________________________________________________________________ 2 – Lift trolley Lift&Drive 20205/20205B...
-
Page 6: Assembly
To disassemble the lift trolley, follow the instructions in section Assembly, but in reverse order. When the lift trolley is due for scrapping the machine, complete with batteries, should be handed in to a recycling centre or Pronomic to ensure reuse and safe handling of all parts. ________________________________________________________________________________... -
Page 7: Using The Lift Trolley
3 Using the lift trolley If the load is left on the lifter for some time it may be necessary to lower the load before it can be raised. 3.1 Handlebar To achieve a good working position the handlebar should be adjusted to a correct height. The handlebar can easily be adjusted in height by loosening the black knobs on the handlebar. -
Page 8: Power Pack
3.3 Power pack Modifying the power pack is dangerous. The device may not be sealed in any way. It should not be exposed to splashed or running water. 3.4 Brakes On lift trolleys equipped with central brake the brake is applied by moving the brake bar to its lowest position. -
Page 9: Maintenance
Further use requires more frequent service intervals. Only spare parts supplied or approved by Pronomic may be used. After disassembly/assembly of the column or load carrier a load test should be performed, see section Assembly. -
Page 10: Every Year, Or When Needed
from sleep mode after charging it takes about two minutes before the voltage indicator shows fully charged. The lift trolley should not be used until the indicator on the actual charger turns green (4-8h). If the lift trolley is used in more than one shift per day an extra power pack per shift is necessary in order to secure fully charged and healthy batteries. -
Page 11: Brakes
5.2.7 Brakes Check that the breaks work. 5.2.8 Knobs for handlebar and bracket for remote control Check that the knobs loosen and tighten correctly. 5.2.9 Replacing the fuse The fuse is located inside the power pack. A wiring diagram for the lift trolley is attached to the inside of the lid of the power pack. -
Page 12: Trouble Shooting
If problems arise, some guidance is provided below. If the problem persists after action has been taken – Please contact service technician or Pronomic. If the load carrier does not move at all, or very slowly: •... -
Page 13: Attachments
7 Attachments Attachments can be divided into groups. Below is a list of approved attachments. If the lift trolley is modified or equipped with other attachments, a supplementary risk analysis must be carried out by the person issuing the declaration of conformity with directive 2006/42/EC. Category Part number Description... -
Page 14: Approved Attachments
7.1 Approved attachments The following table lists the attachments that are approved for each lift trolley model. 15012 15013 15014 15015 15016 15017 15018 15019 15024 15080 15322 15324 15338 15370-15372 16020 16038 16338 16041-16044 16048-16049 17182 17231 17241 17710 17720 17730 17740... -
Page 15: Ec Declaration Of Conformity Of The Machinery
(In accordance with 2006/42/EC, Annex II 1A) Manufacturer Pronomic AB Box 5504 192 05 Sollentuna Sweden Authorized to compile the Samuel Pierre, Pronomic AB, BOX 5504, 192 05 Sollentuna, Sweden technical file Applied EC directives: 2006/42/EC Machinery Directive 2014/30/EU EMC Directive Applied standards: Safety of machinery - General principles for design –... - Page 16 ________________________________________________________________________________ 13 – Lift trolley Lift&Drive 20205/20205B...
-
Page 17: Test Protocol For Lift & Drive
1.25x its max load. This machine has performed flawlessly during the load test. ………………………………………………………………………………………………………….………………………………………………… Serial number ………………………………………………………………………………………… Signature, Inspector ………………………………………………………………………………………… Place, date Pronomic AB – SWEDEN Box 5504 192 05 Sollentuna ________________________________________________________________________________ 14 – Lift trolley Lift&Drive 20205/20205B... - Page 18 ________________________________________________________________________________ 15 – Lift trolley Lift&Drive 20205/20205B...
- Page 19 ________________________________________________________________________________ 16 – Lift trolley Lift&Drive 20205/20205B...
- Page 20 Distributed by: ________________________________________________________________________________ 17 – Lift trolley Lift&Drive 20205/20205B...