Table of Contents
Advertisement
5.8 Loading and unloading
WARNING:
load or remove the load in any
way other than what the trolly are
intended for.
WARNING ! During transport and when
the cart is loaded, have the load carrier in
its lowest position.
The user is responsible for ensuring that the lift trolley
is loaded correctly.
Always apply the brake when loading/unloading.
For maximum stability the center of gravity of the
goods should always be centered on the load
carrier and as close to the column as possible.
Position the load carrier at the desired height before
loading/unloading.
5.9 Display
The display for the trolley is used to select various
settings, functions, retrieve or save information and
to configure the trolley. To use the display, use the
buttons next to the display.
Some of the menus are protected by pincode to avoid
changing important settings/configurations that could
affect the trolleys performance or security.
(If the display doesn't light up raise and low the load
carrier or remove and replace the battery unit. Refer to
chapter 5.7 " Raising and lowering the load carrieror"
or chapter 5.2 "Remove the battery unit from trolley".)
The sub-menus of the The Liftcontrol start menu:
System Info
Service Mgn
Factory Cfg
Do not attempt to lower the
MENU System Info
Batt:
The battery charge in procentage and
in volatage
Chargings:
Number of charges when control unit
connected
Active:
Trolley in active status
Running:
Motortime running
Display Elog:
Fault codes refer to chapter 9.2 "Fault
codes"
Display
stamps:
Info of Active and Running at a date
Compressed
Cfg:
Machine type configuration
SW:
Software version
BCC:
Software version (if it is a LiFePO4
trolley)
MENU Service Mgm
Error log:
Fault codes ref . chapter 9.2 "Fault
codes"
Service
stamps:
Date when service info of Active and
Running when stamp.
BCC Test:
Check if BCC is active
Clear statistics: Clear Active and Running info
Reset system: Restart trolley with update of settings
MENU Factory Cfg.
Menu is protected with a PINCODE
Menu holds settings of
Battery config information, Handcontrol set variant,
Machine type configuration, Motor function motion,
End stop sensor, 24V output tool.
25
Advertisement
Table of Contents
