Kenwood TS-60S Instruction Manual page 48

8 OPERATION USING ACCESSORI
MICROPHONE
Use the following buttons and keys on the MC-47
microphone to control the transceiver:
UP AND DWN BUTTONS
Press the UP or DWN button in the VFO made to
raise or lower the operating frequency. Press either
button in the Memory Channel mode to select any
channel. In the Menu Set-up mode, use the buttons
to switch through all selections of the displayed menu
item. Hold down either button to continuously change
the frequency, memory channel or menu item
selection.
The 100 memory channels are divided into ten groups
of ten channels each, While scanning channels using
Group Scan in Memory Channel mode, pressing either
the microphone UP or DWN button shifts scan to the
adjacent channel group. Group scan resumes
automatically within the new group.
The transceiver frequency step can be changed from
the microphone. Refer to Menu Set-up (Menu A,
No. 16 and No. 17). 10 kHz is the default.
PTT BUTTON
Hold down the PTT button to transmit. Press this
button once while scanning to stop scan. Disable the
PTT button by changing Menu B, No. 65. Refer to
Menu Set-up on page 47.
PROGRAMMABLE FUNCTION KEYS
(MICROPHONE PFi TO PF4 KEYS)
Use the PF keys for Menu Set-up changes, and for
button and special functions listed on page 49.
To assign functions to PF keys, use the following
information:
P mmabi
Menu B No. oka NE. Factory Defaults
{Menu No. 83)
68 PF Transmit power
level switch
| _|__ (Menu No. 08)
TF-SET
oY tbs (Menu No. 36)
70 PF4 Monitor
(Menu No. 82)
48