Kenwood TS-60S Instruction Manual page 24

3 COMMUNICATION
TRANSMISSION
1
2
meet)
Switch off the transceiver.
Plug a key or electronic keyer into the rear panel
KEY jack.
Switch on the transceiver.
Select a transmit frequency using the UP and
DOWN buttons and the tuning control.
Use the UP and DOWN buttons with the MHz
button on (1 MHz displayed) ta change frequency
in 1 MHz steps.
Use the SSB/CW button to select CW.
Operate the key or the electronic keyer to
transmit. Before transmitting, check that you will
not interfere with other stations.
Rear panel
Switch the power off before connecting a key to
the KEY jack. Installing a key into this jack with
the power on will cause the transceiver to
momentarily transmit.
t +7,
Contact current a
GND
Use a commercially available 3.5 mm plug to
connect a keying device.
approximately 1 mA.
HM Delay Time Change
Menu A, No. 05 allows keying delay time selection
{the delay before the transceiver returns to the
receive mode after the key is released).
The default is 600 ms. For details, refer to Menu
Set-up on page 46.
24